How To Reset Fire Alarm Pull Station
Follow your fire drill procedure. A fire alarm pull station is one of two types of initiating devices used in a typical fire alarm system.
Fci pk625 key for fire alarm panel and pulls.
How to reset fire alarm pull station. Closeup manual pull station of fire alarm system installed on the wall next to fire fighters telephone jack, selective focus, safety red pull handle on wall. A ground fault can't be reset, a broken wire can't be reset, a faulty battery can't be reset; To initiate an alarm it is necessary to first lift the upper door marked “lift then pull handle”, and then pull the alarm handle.
If there is a cover on the pull station, lift the cover and then pull the lever on the pull station. In this video, stephan shows you how to reset some common manual pull stations, or fire alarm boxes! In its simplest form, the user activates the alarm by pulling the handle down, which completes a circuit and locks the handle in the activated position, sending an alarm to the
In its simplest form, the user activates the alarm by pulling the handle down, which completes a circuit and locks the handle in the activated position, sending an alarm to the fire alarm control panel. 1347 silent knight pull station, bosch radionics/honeywell this is also known as sc10 key. Easy online ordering for the ones who get it done along with 24/7 customer service, free technical support & more.
The single action station requires a firm downward pull to break the plastic rod visible below the pull lever and actuate the switch to sound the alarm. A emergency brake, close up. The front of the station is hinged and must be opened to reset the station and to replace the plastic rod.
The manual fire alarm box is reset only by opening the hinged housing cover with an allen key and then closing and locking the cover. Maximum pull force to activate. For silent knight fire panel you will need the #1347 key that is in the fire control panel door to reset the pull station.
Notifier fire alarm pull stations are an active fire protection device designed to initiate an alarm on the fire alarm system when activated. There are automatic initiation devices such as smoke detectors and heat sensors that work without human intervention to activate alarms while pull stations provide the ability for a person to trigger the alarm manually. Categories commercial, products, technology, training post navigation.
The handle, once pulled will remain open and cannot be reset without utilizing the screwdriver. Other systems will require a screw driver or an allen wrench set to reset the pull station. To reset, the station is opened using a cat.
Jpg format how to edit? If you are using the siemens firefinder xls control panels, this pull station is what you need for your building. Tamper resistant reset key lock (keyed same.
Reset a fire alarm manual pull station. Notifier fire lite panel & fire alarm pull station reset key 17003. 1347 silent knight pull station, bosch radionics/honeywell.
Resetting is accomplished by inserting a 1/8” screwdriver from the front. Once the alarm is activated you need to reset the pull station immediately. Once the alarm is activated you need to reset the pull station immediately.
These are troubles with the system. Pigtail wires are provided for connection to the facp initiating device circuit. More buying choices $11.00 (15 new offers)
The glass double action station requires that the hammer, hung on Fci pk625 key for fire alarm panel and pulls. Compatible with simplex fire alarm control panels equipped with either idnet or mapnet ii communications.
The pull down lever remains down and locked until the manual fire alarm box is reset. The pull station cover might sound a local alarm, but it doesn't set off the building's fire alarm system. Notifier panel & fire alarm pull station reset key 17021.
Notifier fire alarm pull stations are an active fire protection device designed to initiate an alarm on the fire alarm system when activated. Notifier panel & fire alarm pull station reset key 17021. A pull station meeting ul 38, the company’s standard for manual signaling boxes for fire alarm systems, has been examined, tested, and confirmed to resist problems caused by impact, use, corrosion, weather, and other factors.
The alarm handle latches in the pulled position until the station is manually reset. To set off the building's fire alarm system, you have to pull the lever.